EasyManua.ls Logo

Avalon Bay 100B - Troubleshooting; Food sealer does not work; Air is not vacuumed from the bag; Bag melts

Avalon Bay 100B
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Avalon Bay Food Sealer Product Guide
12
http://www.avalon-bay.com
Troubleshooting
Nothing happens when I press both sides of the lid to vacuum
Problem
Possible cause/Solution
Food sealer does not work
Make sure the power cord is correctly plugged into the
electrical outlet.
Make sure the power cord is not damaged in any way.
Make sure the electrical outlet is operative by plugging in
another appliance. If it’s not, please check the circuit breakers
or fuses in your home.
Make sure the bag is positioned correctly down in the sealing
foam chamber.
Wait 25 minutes to allow appliance to cool off, and then try
using again.
Air is not vacuumed from the bag
Problem
Possible cause/Solution
Air is not vacuumed from the
bag
Check that there are no gaps, folds, wrinkles, or holes in the
pre-sealed bags.
Check for loose, worn or cracked UPPER and LOWER sealing
gaskets.
Foods with high liquid contents may prevent the bag from
sealing properly. Cut bag open and wipe top inside of bag and
reseal.
Make sure you have placed the bag in the proper place. When
making a bag from a roll, make sure end of cut piece is on the
sealing bar.
Bag melts
Problem
Possible cause/Solution
Bag melts
The sealing strip may have been too hot during the sealing
process. Allow the unit to cool for 20 seconds between uses.
If the bag continues to melt, allow unit to cool with the lid in
the upright position for 25 minutes before using.