Avalon Arbor - Page 28

28 Operating Your Appliance
© Travis Industries 100-01190_003 4100818
Burn Procedure Pictorial Overview (continued)
Now that the unit is hot and has a good coal bed,
fill the unit with wood, wait a few minutes then
close the bypass and adjust the air control to low.
4 HOURS
- This picture was taken 4 hours into a
low burn.
8 HOURS
- This picture was taken 8 hours into a
low burn.
13.5 HOURS
- This picture was taken 13.5 hours
into a low burn.
After 13.5 hours you can re-start the fire by opening the bypass and air control and placing some kindling
in the stove. After the fire starts burning you can load more wood and repeat the burn process. The
glass may become dirty on low burn. By burning on high, with a hot stove, the glass will become clean.