To Next PageTo Next Page
Need help?Do you have a question about the Avalon Newport and is the answer not in the manual?
User needs to provide model, serial number, purchase date, and from whom for warranty.
Details on heating capacity, burn rate, and hopper capacity.
Physical measurements of the stove and vent sizes.
Power rating, voltage, amperage, and frequency requirements.
Specifies the type and standards for approved wood pellets.
Heater's EPA status and testing information.
Crucial instructions to read the manual and check with local officials before starting.
Lists all items included with the stove.
Describes various compatible installation types and vent configurations.
Guidance on sketching plans, checking dimensions, and locating studs.
Requirements for placing the stove regarding clearances to combustibles.
Specifies the type and dimensions of floor protection needed.
Diagram and measurements for clearances in straight vent installations.
Diagram and measurements for clearances in corner vent installations.
General rules for pellet vent installation, clearances, and elbow limits.
Chart showing maximum vent height and run based on diameter.
Specifies approved vent types (Type 'L', Type 'A' chimney).
Details on sealing vent sections and screw requirements.
Requirements for vent termination location and clearances.
Specific installation rules for mobile homes, including bolting and outside air.
Requirements and recommendations for using outside air for combustion.
Specific dimensions and clearances for alcove installations.
Explains how to adjust the restrictor for optimal airflow.
Diagram illustrating a direct wall vent installation with clearances.
Diagram showing a vertical vent installation through the ceiling.
Diagram for installing the stove with a Type A chimney.
Diagram for connecting to a masonry or zero-clearance fireplace.
Reinforces critical safety warnings before stove operation.
Identifies the location of the control panel, thermostat, and restrictor.
Details initial steps like paint curing and priming before first use.
Instructions on how to properly fill the pellet hopper.
Explains manual and auto modes for controlling the heater.
Describes the procedure and effects of changing modes during use.
Detailed steps for starting, shutting down, and adjusting heat in manual mode.
Instructions on using the heat buttons to control output.
Steps for safely turning off the heater.
Details on using the thermostat for automatic temperature control.
Guidance on setting the thermostat for desired room temperature.
Instructions on adjusting heat output within auto mode.
Steps for safely turning off the heater.
Explains how to adjust the restrictor for optimal air flow and flame.
Symptoms and solutions for insufficient airflow.
Symptoms and solutions for excessive airflow.
Instructions on how to change the fan speed using the control panel.
Details the automatic start-up process and its parameters.
Function of the button used to prime the auger.
Explains the indicator light for the auger.
Explains what the fault light indicates and how to reset it.
Lists fault codes for service technicians.
How the stove behaves during and after power outages.
Routine checks including burn inspection and pellet level.
How to identify and address clinkers in the firepot.
Step-by-step guide to cleaning the firepot after cooling.
Maintenance tasks performed every 10 bags, like cleaning heat tubes.
Instructions for cleaning the heat exchange tubes.
How to clean out the pellet hopper.
Guidance on cleaning gold-plated parts to prevent etching.
Detailed steps and warnings for opening the stove door for service.
Instructions for cleaning ash from the firebox into the ashpan.
How to check and dispose of ashes from the ashpan.
Steps for cleaning the stove door glass.
Comprehensive annual maintenance tasks for optimal performance.
Instructions for cleaning vertical exhaust ducts.
Instructions for cleaning horizontal exhaust ducts.
Steps for cleaning the exhaust blower motor and housing.
How to clean the pellet vent system, including checking for build-up.
Procedures to identify and fix air leaks affecting performance.
A list of available replacement parts with part numbers.
Describes the sound produced by the exhaust blower.
Describes sounds from heated air passing through tubes.
Describes the clicking sound of pellets in the firepot.
Describes the buzz sound from the auger motor.
Describes the hum produced by the convection fan.
Emphasizes the importance of the safety label.
Table detailing required clearances for various installation types.
Specifies maximum alcove depth and minimum ceiling height.
Crucial warnings about hot surfaces and fire hazards.
Details warranty coverage for parts and labor in the first two years.
Details warranty coverage for parts and labor for years three to five.
Details warranty coverage for parts only in years six and seven.
Outlines the conditions and exclusions that nullify the warranty.
Steps to follow when seeking warranty service.
Instructions for installing the optional thermostat.
Information on installing and using the remote thermostat.
Instructions for installing the optional log set.
Instructions for installing the optional gold grill.
Instructions for installing the optional gold door.
User needs to provide model, serial number, purchase date, and from whom for warranty.
Details on heating capacity, burn rate, and hopper capacity.
Physical measurements of the stove and vent sizes.
Power rating, voltage, amperage, and frequency requirements.
Specifies the type and standards for approved wood pellets.
Heater's EPA status and testing information.
Crucial instructions to read the manual and check with local officials before starting.
Lists all items included with the stove.
Describes various compatible installation types and vent configurations.
Guidance on sketching plans, checking dimensions, and locating studs.
Requirements for placing the stove regarding clearances to combustibles.
Specifies the type and dimensions of floor protection needed.
Diagram and measurements for clearances in straight vent installations.
Diagram and measurements for clearances in corner vent installations.
General rules for pellet vent installation, clearances, and elbow limits.
Chart showing maximum vent height and run based on diameter.
Specifies approved vent types (Type 'L', Type 'A' chimney).
Details on sealing vent sections and screw requirements.
Requirements for vent termination location and clearances.
Specific installation rules for mobile homes, including bolting and outside air.
Requirements and recommendations for using outside air for combustion.
Specific dimensions and clearances for alcove installations.
Explains how to adjust the restrictor for optimal airflow.
Diagram illustrating a direct wall vent installation with clearances.
Diagram showing a vertical vent installation through the ceiling.
Diagram for installing the stove with a Type A chimney.
Diagram for connecting to a masonry or zero-clearance fireplace.
Reinforces critical safety warnings before stove operation.
Identifies the location of the control panel, thermostat, and restrictor.
Details initial steps like paint curing and priming before first use.
Instructions on how to properly fill the pellet hopper.
Explains manual and auto modes for controlling the heater.
Describes the procedure and effects of changing modes during use.
Detailed steps for starting, shutting down, and adjusting heat in manual mode.
Instructions on using the heat buttons to control output.
Steps for safely turning off the heater.
Details on using the thermostat for automatic temperature control.
Guidance on setting the thermostat for desired room temperature.
Instructions on adjusting heat output within auto mode.
Steps for safely turning off the heater.
Explains how to adjust the restrictor for optimal air flow and flame.
Symptoms and solutions for insufficient airflow.
Symptoms and solutions for excessive airflow.
Instructions on how to change the fan speed using the control panel.
Details the automatic start-up process and its parameters.
Function of the button used to prime the auger.
Explains the indicator light for the auger.
Explains what the fault light indicates and how to reset it.
Lists fault codes for service technicians.
How the stove behaves during and after power outages.
Routine checks including burn inspection and pellet level.
How to identify and address clinkers in the firepot.
Step-by-step guide to cleaning the firepot after cooling.
Maintenance tasks performed every 10 bags, like cleaning heat tubes.
Instructions for cleaning the heat exchange tubes.
How to clean out the pellet hopper.
Guidance on cleaning gold-plated parts to prevent etching.
Detailed steps and warnings for opening the stove door for service.
Instructions for cleaning ash from the firebox into the ashpan.
How to check and dispose of ashes from the ashpan.
Steps for cleaning the stove door glass.
Comprehensive annual maintenance tasks for optimal performance.
Instructions for cleaning vertical exhaust ducts.
Instructions for cleaning horizontal exhaust ducts.
Steps for cleaning the exhaust blower motor and housing.
How to clean the pellet vent system, including checking for build-up.
Procedures to identify and fix air leaks affecting performance.
A list of available replacement parts with part numbers.
Describes the sound produced by the exhaust blower.
Describes sounds from heated air passing through tubes.
Describes the clicking sound of pellets in the firepot.
Describes the buzz sound from the auger motor.
Describes the hum produced by the convection fan.
Emphasizes the importance of the safety label.
Table detailing required clearances for various installation types.
Specifies maximum alcove depth and minimum ceiling height.
Crucial warnings about hot surfaces and fire hazards.
Details warranty coverage for parts and labor in the first two years.
Details warranty coverage for parts and labor for years three to five.
Details warranty coverage for parts only in years six and seven.
Outlines the conditions and exclusions that nullify the warranty.
Steps to follow when seeking warranty service.
Instructions for installing the optional thermostat.
Information on installing and using the remote thermostat.
Instructions for installing the optional log set.
Instructions for installing the optional gold grill.
Instructions for installing the optional gold door.
General| Brand | Avalon |
|---|---|
| Model | Newport |
| Category | Pellet stove |
| Language | English |
