- 7 -
User Manual
Draft Beer Tower Installation
Installing Draft Tower
1. Connect beer line connector to keg coupler.
2. Place rubber washer over draft arm
mounting holes in cabinet.
3. Put beer line connector down through hole.
4. Secure draft arm with four screws.
5. Insert air hose in draft arm, being careful
not to disturb insulation.
6. Remove top cover of draft arm and attach
air hose clip to the insulating sleeve at the
top of the draft arm. This will assure that the
hose remains in the proper place at all times,
which will keep the beer faucet cold.
7. Replace top cover.
8. Screw the handle onto the beer faucet.
1
32 4
7
6 8
5
Beer Tower
Install Contents
To Next Page
Loading...
