User Manual
www.AvantcoEquipment.com 15
Troubleshooting
Trouble Possible Causes Solution
The axles can’t work when
operating the machine
Poor contact of the electrical
equipment
Check the Plug
The mixing bowl is out of position Moving direction is not correct
Change
Leaks oil Sealing washer is damaged Change
Difficult to move the bowl up and down Slideway is rusted Clean the slideway and lubricate
The motor is overheated
and speed is down
The voltage is not enough, or
incorrect speed
Check the voltage or use
lower speed
Noise and overheating Poor lubrication Add or change lubrication
Mixer touches bowl The mixing device or bowl de-
formed
Repair or change the bowl
or mixing device
Cleaning
WARNING: DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE CLEANING
!
All new mixer bowls and accessories including whips, beaters, and dough hooks should be properly washed before use.
Wash with hot water and a mild soap solution and then rinse off with either a mild vinegar or soda solution and then rinse
again with clean water. It is highly recommended this cleaning procedure is followed for bowls and accessories prior to
whipping egg whites or whole eggs. The mixer should be cleaned daily with a clean damp cloth.
If the unit has not been used for some time, it is recommended that the procedure above is followed before mixer use.
It is important that the rear bowl lift guides are greased every three months to prevent corrosion.
To Next Page
Loading...
