Avantes AVASPEC-128 - AvaLight-DHc Compact Deuterium Halogen light source

88 Apr-09
Avantes www.avantes.com info@avantes.com
LED Lamp replacement
1. Plug out the power connector from the
socket.
2. Remove screw protection caps on the
frontside
3. Loosen 2 screws with philips
screwdriver
4. take out the frontplate and electronics
board
5. untighten 2 screws from LED socket
6. slightly bend the electrical wires out of
LED socket
7. take out the LED from LED front holder
8. replace by new LED, make sure the
Anode and Kathode are connected in the same way and LED legs make no short circuit.
9. Apply power to see if the LED is illuminating
10. Slide back electronics board and front plate, tighten screws and put back screw caps
Technical Data
AvaLight-LED380
AvaLight-LED400
AvaLight-LED470
AvaLight-LED590
Power Supply
12 VDC/ 800mA
Spectral
Range*
380 nm
400 nm
470 nm
590 nm
FWHM (nm)
15 nm
11 nm
30 nm
30 nm
LED output
10 µWatt
25 µWatt
25 µWatt
25 µWatt
Connector
SMA 905
Power Supply
12 VDC(+inside, GND outside), 40 mA
Dimensions
175 x 110 x 44 mm
* other wavelengths available on request
Ordering Information
AvaLight-LED-XXX
Light Emitting Diode Lightsource, specify wavelength XXX
AvaLight-LED-470-p14
Light Emitting Diode Lightsource, 470 nm for use with AvaSoft-Oxy
AvaLight-LED-XXX-RM
Rackmount version of the Light Emitting Diode Lightsource, specify wavelength
XXX
IC-DB15-2
Interface cable AvaSpec-USB1 platform to AvaLight-LED
IC-DB26-2
Interface cable AvaSpec-USB2 platfom to AvaLight-LED for PWM
PS-12V/1.0A
Power supply 100-240 VAC/12VDC, 1.0 A for AvaLight-LED
Screws LED
Socket
LED front
holder