1.2. The USB hub
1.4. Safely transporting the ClassVR hardware
1.3. Charging the headsets
The USB hub mounted in the top left corner of the case is used to charge each headset via
the connected cables. When the unit is charging you will see a green light appear on the
hub. The power switch can be found on top of the hub.
The headset case comes complete with a sliding handle built into the back. To access the
handle simply pull it upwards until it clicks into position. Push down to unlock the handle
and it will easily slide back into the case.
To charge the headsets, carefully place them back into the carry case making sure the
headset power button is facing up and the micro USB cable is accessible. Connect
the cable to the micro USB port on the bottom of the headset. The light above the
connector will turn blue to show that it is charging.
Make sure the power button on the headset is facing up when placed back into
the case. This ensures that the micro USB socket will be on the correct side.
Make sure the headsets are fully charged before first use.
4 5
To Next Page
Loading...