What to do if Avaya Wireless Access Point is not receiving power?
If your Avaya Wireless Access Point is not receiving power, check the CAT-5 cable connections. Confirm the AP's health using the WMS or WC 8180 CLI. Also, verify that an Avaya-approved PoE source is supplying power to the AP.
What to do if Avaya AP 8120 Wireless Access Point is waiting for boot instructions?
If your Avaya Wireless Access Point is waiting to receive boot instructions and a configuration file from a WC 8180, wait a few seconds for the boot process to begin. If the LED remains amber, try the remedies for the other health LED appearances. If the LED still remains amber, ensure the AP is securely connected to its PoE source and to the network.
What to do if Avaya Wireless Access Point is starting with image from WC 8180?
If your Avaya Wireless Access Point is starting with an image received from a WC 8180, wait a few seconds for the boot process to complete. If this LED appearance persists, enable a radio or place a radio in sentry mode.
Explains the different states and meanings of the AP's LEDs.
Details RJ-45 port, CAT-5 cables, and power delivery for the AP.
Advises on radio energy transmission and configuration.
Procedure for mounting the AP on a wall.
Procedure for installing the AP using a ceiling grid adaptor.
Diagnoses issues based on LED status and provides remedies.
General| Model | AP 8120 |
|---|---|
| Wireless Standards | 802.11a/b/g/n/ac |
| Frequency Bands | 2.4 GHz, 5 GHz |
| MIMO Technology | 2x2 MIMO |
| Power over Ethernet | 802.3af/at |
| Antenna Type | Internal |
| Ethernet Ports | 2 x 10/100/1000 Mbps |
| Mounting Options | Wall, Ceiling |
| Security | WPA2, 802.1X |
| Management | SNMP |
| Operating Temperature | 0°C to +40°C |
To Next Page
