Avaya DECT R4 - Slave Base Station Configuration

DECT R4 Page 143
15-601047 Issue 03a (21 February 2011)IP Office Release 7.0
Non-Provisioned Installation: Master Base Station Configuration
8.5 Slave Base Station Configuration
The base station installation process consists of the following stages:
1.
Default the base station.
2.
Access the base station configuration.
3.
Update the base station firmware.
4.
Set the base station IP address.
5.
Set the base station to slave mode.
6.
Reset the base station.
7.
Check the base stations.