Figure 16: Status LEDs
2.
View the status LED states to verify that the fan trays and power supplies are
installed and operating correctly. You can also verify the status and operating mode
of the unit.
For status LED state descriptions, see the following table.
Table 1: Status LED descriptions
LED State Description
Base Off The unit is operating in standalone
mode. If in a Stack, the switch is not
a Base unit or a Temporary Base
unit.
Amber (Solid) The unit is operating as the
Temporary Base unit.
Amber (Blinking) The unit has a Base unit election
problem. Multiple units are
configured with a Base unit switch
on, or no unit has the Base unit
switch on.
Amber (Fast Flashing) The unit did not join the Stack. Refer
to the log for more information.
Checking status LEDs to verify switch installation
VSP 7000 installation July 2013 39
To Next Page
Loading...
