• When a port on VSP 7254XSQ is disabled or enabled, or a cable replaced, or the switch
rebooted, the remote link can flap twice.
• Avaya recommends enabling auto-negotiation to ensure proper operation at 100 Mbps speeds
on VSP 7254XTQ:
-
Link instability will be seen if both ends are set to 100 Mbps auto-negotiation disabled and
you use a straight through cable.
- If Link instability is seen when you use a cross-over cable, a port disable or enable can fix
the issue.
For more information, see Installing Transceivers and Optical Components on VSP Operating
System Software, NN47227-301.
Hardware models for VSP 7200 Series
November 2016 Installing the Avaya VSP 7200 Series 13
Comments on this document? infodev@avaya.com
To Next Page
Loading...
