Chapter 4: Preinstallation checklist
Preinstallation checklist
Before you install the Avaya Virtual Services Platform 7200 Series, make sure that you complete the
tasks in the preinstallation checklist.
Important:
Make sure the air flow direction of your power supplies and fan modules match the same
direction (either front-to-back or back-to-front).
No. Task Description
1. Review the technical specification for
the switch. Make sure that the area
where you install the switch and where
it will operate meet the requirements.
For the physical, electrical, and environmental
specifications, see Technical specifications on
page 19.
2. Verify the power supply unit (PSU)
specifications. Optionally order a
redundant PSU to provide redundancy
and load sharing.
See AC power supply specification on
page 24 or DC power supply
specifications on page 31.
To order redundant PSUs, see Hardware
models for VSP 7200 Series on page 8 for part
numbers.
3. Verify that the fan module air flow is
going in the same direction as the
power supplies (either front-to-back or
back-to-front). Optionally order
redundant fan modules.
To order redundant fan modules, see
Hardware models for VSP 7200 Series on
page 8
for part numbers.
4. Make sure that you have the following
tools and cables:
• Phillips #2 screwdriver
•
RJ-45 console port cable
• ESD cable
See Cable requirements for the VSP 7200
Series on page 72.
5. Unpack the equipment. Observe ESD precautions when you unpack
the equipment. See Electrostatic discharge on
page 18.
Table continues…
November 2016 Installing the Avaya VSP 7200 Series 14
Comments on this document? infodev@avaya.com
To Next Page
Loading...
