Rails
The following figure shows a slide rail in the default configuration for a 300mm-600mm equipment
rack. This configuration comes with the short rear bracket installed. The slide rail actually consists of
two separate rails that slide into each other:
• Rack rail—This rail is the main component that connects to the equipment rack.
• Chassis rail—This rail is embedded in the rack rail. Later, the installation instructions explain
how to detach these two rails and install the chassis rail onto your switch.
Figure 7: Rails
Brackets
There are three different brackets:
• Short rear bracket—The slide rail kit comes with this bracket installed for the 300mm-600mm
default configuration.
Installing the switch in an equipment rack
November 2016 Installing the Avaya VSP 7200 Series 41
Comments on this document? infodev@avaya.com
To Next Page
Loading...
