Label Color and Status Description
Green (blinking) The port has established a link and there is data activity.
Green (slow blinking) The port is administratively disabled.
Management port LED state indicators
The management port is on the rear of the chassis between the fans and the right-hand power
supply (PSU2). The management port is the RJ–45 jack above the console port.
The management port provides 10/100/1000 BaseT Ethernet connectivity and uses two bi-colored
LEDs to indicate the activity and speed of the link.
• The LED on the top of the port (
Speed) indicates the current speed of the port.
• The LED on the bottom of the port (Link/Act) indicates the status of the link and whether or not
it’s active.
Table 15: Management port LED state indicators
Label Color and Status Description
Speed Off The port is operating at the low speed.
Amber (steady) The port is operating at mid speed.
Green (steady) The port is operating at high speed.
Link/Act Off The port has no data activity.
Amber (steady) The port has a fault.
Amber (blinking) The port is enabled, but it has not established a link.
Green (steady) The port has established a link, but there is no data activity.
Green (blinking) The port has established a link and there is data activity.
Green (slow blinking) The port is administratively disabled.
Enterprise Device Manager (EDM) representation of physical LED
status
EDM displays the same LEDs that you see on the physical device.
Note:
LED blinking in EDM is representative of, but not identical to, the actual LED blinking rates on
the switch.
For more information about the LEDs and a description of the blinking rates, see the preceding LED
sections.
Installing the Avaya Virtual Services Platform 7200 Series
November 2016 Installing the Avaya VSP 7200 Series 38
Comments on this document? infodev@avaya.com
To Next Page
Loading...
