Figure 11: Thumbscrew lock
• White release latch—This latch is the white, plastic tab on the chassis rails.
- When you first install the slide rails, use these latches to disconnect the chassis rail from the
rack rail so you can install the chassis rail on the switch.
- After you install the switch in a rack, you can use the white release latches to remove a
switch from an equipment rack, if necessary.
Figure 12: White release latch
• Blue release latch—This latch is a blue, plastic tab that is also on the chassis rail. Use these
latches to slide the switch into the equipment rack.
Installing the Avaya Virtual Services Platform 7200 Series
November 2016 Installing the Avaya VSP 7200 Series 44
Comments on this document? infodev@avaya.com
To Next Page
Loading...
