www.factorybuysdirect.com
7160946-03A
WARNING: Attach heater in
heater in a horizontal position.
This could lead to dangerous
TO START HEATER
WARNING: When lighting the
side of the heater during ignition.
WARNING: MAKE SURE
THERE IS NO OPEN FLAME IN
on the propane cylinder.
Read all lighting instructions before attempting
to ignite heater.
1. Turn the heater regulator knob counter-
clockwise
to the OFF position.
2. Place a lit match near the face of the heat-
ing element (mesh screen) of the burner
you are lighting, Locate the ignition hole
located on the bottomof the burnerr. (see
Figure 2.)
CAUTION: Do not light at the
3. Press button on safety valve admitting gas
to burner (see Figure 2).
4. When the gas on the face of mesh screen
lights, continue to hold valve button
pressed for 30 seconds, then release.
repeat lighting procedure.
6. If heater will not light after repeated tries,
do not attempt to repair heater. Call Cus-
tomer Service toll free at
WARNING: DO NOT LEAVE
HEATER UNATTENDED WHILE
OPERATING
OPERATION
Figure 2 - Lighting Heater With a Match
7. Choose either HIGH or LOW setting for
operation depending on the heating
requirements.
LIGHTING UNDER WINDY
CONDITIONS
When lighting this heater outdoors on a
windy day, it will be necessary to use a long
match or long stem butane lighter to ignite
o
keep the match lit long enough under windy
conditions. Follow the “Lighting instructions”
procedure after doing the following:
1. Position the heater and tank such that
the Thermocouple faces away from the
wind.
2. Position your body behind the heater
such that your body blocks the wind
while you are following the instructions
for lighting.
To Next Page
Loading...
General