avenli SPA4 - Spa Usage and Controls; Control Panel Overview; Key Functions Explained

13) Put the filter cartridge
in the support then screw
it onto the lower suction
inside the basin. Cartridge
location as shown.
14) Ensure that the drain
caps are properly closed
before filling the spa.
15) Smooth wrinkles out of
the bottom of the spa, then
fill the spa to the level
indicated. Your spa is
ready.
Usage
Control panel
Functions
Once powered-up, the LED displays the current water temperature automatically.
The temperature units selector changes the temperature units from Celsius
degrees to Fahrenheit degrees.
Press the temperature adjustment buttons, then the screen will flash. When it is
flashing, you can set the desired temperature. The value will increase or
decrease 1 degree at once. The temperature could be set between 30°C to 40°C
(86°F to 104°F).
Filtration
LED Display
Temperature
Increase Button
Heat Button
Massage Button
Lock Button
Temprerature
units indicator
Temprerature
units selector
Temprerature
Decrease Button