avenli SPA5 - User Manual

Questions and Answers

L
lisa61Aug 2, 2025
What to do if the water filtration in my avenli SPA5 does not work?
- S
  Susan RiddleAug 3, 2025
  If the water filtration in your Avenli Swimming Pool isn't working, it could be due to a dirty filter cartridge, so clean or replace it. The inlet and outlet might be blocked, so clean them. Air inside the pump can also cause this issue, so fill the water to the minimum level. If the problem persists, there might be a malfunction of the pump unit, and you should call for service if it does not reset.
D
Donna GutierrezAug 7, 2025
What to do if my Avenli Swimming Pool has a leakage?
- T
  Tiffany WrightAug 7, 2025
  If your Avenli Swimming Pool is leaking, it's likely because the spa pool is torn or punctured. Use the provided repair kit to fix it.
C
Cynthia WilliamsonAug 11, 2025
Why is the water not clean in my avenli SPA5?
- S
  Shawn DavisAug 11, 2025
  If the water in your Avenli Swimming Pool isn't clean, it could be due to several reasons. You might not be filtering the water long enough, so try increasing the filtering time. The filter cartridge might be dirty, so clean or replace it. The initial water you used to fill the pool might be of poor quality, consider changing the water completely. Finally, you might not be treating the water properly; in this case, refer to the chemical manufacturer’s instructions.
S
Stephanie ChavezAug 15, 2025
Why is my avenli SPA5 SPA pump not heating properly?
- I
  imillerAug 15, 2025
  If the SPA pump of your Avenli Swimming Pool isn't heating properly, there are a few things to check. First, make sure the temperature isn't set too low and increase it if needed. A dirty filter cartridge can also cause this issue, so clean or replace it. Also, ensure the water level isn't too low; fill it to the minimum level. If none of these steps work, the heating element might be defective, and you should call for service.
W
waynelangAug 19, 2025
What to do if the control panel screen does not operate on my Avenli Swimming Pool?
- J
  John LeeAug 19, 2025
  If the control panel screen of your Avenli Swimming Pool does not operate, it could be due to a power failure, so check the power source. Try resetting the RCD plug and check if the wiring system is adapted to the power of the pump unit. If it does not reset, call for service.
T
Trevor JohnsonAug 25, 2025
Why is the bubble massage system not working on my Avenli Swimming Pool?
- A
  Alisha PierceAug 25, 2025
  If the bubble massage system in your Avenli Swimming Pool isn't working, it could be due to the pump overheating. Cut off the power and wait until the pump has cooled. Alternatively, the auto shut-down feature (30min) might be activated; press the bubble button to reactivate it. If the problem persists, there may be a malfunction of the pump unit, and you should call for service if it does not reset.
D
daniel30Aug 28, 2025
How to fix a pump leakage in my Avenli Swimming Pool?
- D
  davissarahAug 28, 2025
  If you notice a pump leakage in your Avenli Swimming Pool, it might be due to an improperly fitted adaptor seal, so replace the seal in the right position. If the water is leaking from the pump body, check the pump body and call for service.