AVer VC520 Pro3 - Remote Control

English-5
Remote Control
Camera Select
Camera Directional
Control
OSD Menu*
SmartFrame
Zoom In/Out
Preset
Call/Answer
Brightness -
Enter*
Mute/Un-mute
V
olume Up/Down
Preset Hot Key
Preset Position
Hang up
Brightness +
*Not supported for VC520 Pro3

AAA Batteries (required)

Preset ( ): The Preset button on the
remote serves 2 functions.
To Save a Preset - Move camera to desired
position. Press and hold the preset button
until you receive the save message on the
screen. Select preset position button 0-9 to
store the current camera position. Repeat
steps if needed.
To Load a Preset - Press the preset button
and preset position button 0-9 to load a saved
camera position. Repeat steps if needed.

Press and hold the number button “ ” for 1
second to turn on or off the WDR function.

Press and hold the number button “ ” for 1
second to turn on or off the SmartFrame
function.

Press and hold the number button “ ” for 1
second to enable or disable RTMP streaming
function.

Press and hold the number button “ ”
for 1 second to force camera to enter
sleep mode. This will end any video
streaming. To wake up the camera,
press the button or any directional button
for 1 second. This mode is not functional
while USB streaming is on.

Camera Select ( ): If you
only have one camera and do not need
to adjust any setting, the default is
camera 1. If you press camera 2 or 3 on
the remote control, you will find your
remote can’t control your camera. In this
case, please press camera 1 on your
remote again.

SmartFrame ( ): Press for 1 second
to switch the SmartFrame function
among Manual Framing/Auto Framing/
Preset Framing/Smart Composition
modes. A message (as figures shown)
will display on the screen to indicate the
mode.
[Note] SmartFrame deploys face and
body detection technology. People
wearing masks and side facial profiles
can still be detected. The maximum
detection distance is 7-10 meters.
Set up preset points in advance (Only for
Preset point 1-9. Preset 0 is for home
position).