How to fix 'UnderLoad!' error on Avery Weigh-Tronix GSE 60?
If your Avery Weigh-Tronix Controller displays 'UnderLoad!', check the load cell connections. If you are using a 4-wire load cell cable, ensure that the sense jumpers are properly installed.
What to do if Avery Weigh-Tronix GSE 60 Controller shows 'WRONGCODE!'?
If your Avery Weigh-Tronix Controller displays 'WRONGCODE!', you need to enter the correct code to access the Setup Mode. Alternatively, you can press the [ENTER] key alone to view the selections without making any changes.
What does 'CHECK JUMPR' mean on my Avery Weigh-Tronix GSE 60 Controller?
The 'CHECK JUMPR' message on your Avery Weigh-Tronix Controller indicates that the installation of the jumper prohibits programming changes.
What does 'Tare>F.S.!' mean on my Avery Weigh-Tronix Controller?
If your Avery Weigh-Tronix Controller displays 'Tare>F.S.!', it is most likely that the entered tare value was incorrect.
What should I do if the displayed weight on my Avery Weigh-Tronix GSE 60 Controller is incorrect?
If the displayed weight on your Avery Weigh-Tronix Controller is incorrect, power it down for a few seconds. If the indicator still does not work properly after powering it up, check the load cell or platform wiring.
General| Communication | RS-232, RS-485 |
|---|---|
| Enclosure | NEMA 4X |
| Serial Ports | RS-232 |
| Power Supply | 24 VDC |
| Operating Temperature | -10°C to +40°C |
| Enclosure Rating | NEMA 4X |
| Display | 6-digit, 7-segment, 0.56" (14.2 mm) LED |
To Next Page
