8
English
English
Connecting to the Network Video Recorder
Important: To avoid networking problems, only use network switches
recommended by Avigilon.
Connect the camera to the same network as the server running the
Avigilon Control Center software. An IP address is automatically
assigned to the device, and will be detected by the software. For more
information on how to configure the connection, see the software user
guide.
The connection status LEDs show the progress in connecting to the
server and are described in the following table.
Table:Connection Status LED States
Connection
State
Connection
Status LED
Description
No Link Off Not physically connected to any
network device
Obtaining IP
Address
One short
flash every
second
Attempting to obtain an IP address
Connecting to
a server
Two short
flashes every
second
An IP address has been obtained
and is attempting to connect to the
server
Upgrading
Firmware
Two short
flashes and
one long flash
every second
Updating the firmware
Connected On Connected to the server
To Next Page
Loading...
