Enabling Onboard Storage
To use the camera’s onboard storage feature, you must first insert an SD card into the camera. Refer to the
camera’s installation manual for the location of the SD card slot.
1. On the Onboard Storage page, select the Enable Onboard Storage check box.
2. If you prefer, select the Record only when server connection is interrupted check box. Otherwise, the
camera will record video to the network video management server and to the SD card.
3. Select one of the following recording modes:
l Continuous: the camera never stops recording to the SD card.
l On Motion: the camera only records when there is motion in the scene.
If you are configuring an Avigilon video analtyics camera, the On Motion setting will record either
pixel change in the scene or analytics motion events depending on how the camera is configured
in the Avigilon Control Center Client software.
The recorded video will be divided into files no more than five minutes in length or 100MB in size.
4. On the Compression and Image Rate page, make sure the format is set to H.264 to maximize the SD card
recording capacity and performance.
Downloading Recorded Video From the Web Interface
Listed in the Recordings section are all the videos that have been recorded to the SD card.
18 Enabling Onboard Storage
To Next Page
Loading...
