AVIRE DCP - GENERAL INSTALLATION AND SAFETY INFORMATION; Environmental Conditions and Maintenance; Critical Safety Precautions; Battery Management and Disposal

4G DCP IG (AU) V01:EP09/04/2020
Avire Global Pte Ltd
Suite 39
110-116 Bourke Road
Alexandria, NSW 2015
Australia
T: 02 9669 1102
E: sales.au@avire-global.com
W: www.avire-global.com
ENVIRONMENT CONDITIONS
This device is designed to be used indoors (0
o
C to 45
o
C with relative humidity between
20% to 80% not condensing). Sudden changes of temperature and humidity should be
avoided.
CLEANING AND MAINTENANCE
Use a soft dry cloth. Do not use solvent or abrasive products.
SAFETY
Please read these safety instructions before starting the device.
+ Do not expose this device to liquids or excessive humidity. The DCP is an indoor device and
is not waterproof.
+ Do not expose the device to re.
+ Do not try to modify the device.
+ Do not use the device in potentially hazardous areas or where there is risk of explosion.
The DCP emits low levels of radio frequency when in operation.
BATTERY
The DCP includes a NiCd 12 V/600 mAh battery that allows it to keep functioning in the
event of a mains power failure.
This battery should be replaced every 4 years. Only install batteries authorized by Avire,
and only allow qualied personnel to replace the battery.
This battery should be properly recycled and not disposed of with unsorted household
waste. Please take all neccessary precautions when changing the battery.
DISPOSAL
The device complies with regulations 2002/95/CE and 2003/108/CE regarding
the use and disposal of hazardous substances in electric appliances.
Do not dispose of this device with unsorted household waste. Disposing
of the device in an unauthorised way could result in a ne in line with local
regulations.
ENVIRONMENTAL REGULATIONS
RoHS - Avire certies that its production process complies with the 2011/65/EU
European Directive of 03 January 2013 regarding the restriction of use of hazardous
substances in electric and electronic appliances.
INSTALLATION
The equipment is intended for installation in restricted areas by qualied personnel.
GENERAL NOTE
Any wiring or plug used together with the equipment must be certied in line with
relevant product standards. The wiring insulation must comply with the applicable IEC
60332 or IEC 60695/11/21 standards.
This device must be installed by qualied personnel and always in a restricted area
where only such personnel have access.