Avital Champion Mark II - User Manual

Select locations for engine compartment accessories.

Route and connect wires to components using supplied connectors.

Make final wiring connections at the battery.

Program the timer if connected to other options.

Adjust sensor sensitivity (refers to page 15).

Description of the 2-button/3-channel remote and its functions.

Procedures for arming, disarming, and silent operation of the system.

How to activate the panic feature and optional accessories.

How ESP protects the system from scanners.

Prevents engine starting when the system is armed.

System arms automatically 30 seconds after doors are closed and locked.

Customize the automatic door locking behavior.

Bypasses alarm functions for service or when losing the remote.

Allows remote control of convenience features in valet mode.

System automatically locks doors on ignition on and unlocks on ignition off.

Set up the warning response for sensor tamper detection.

System performs tests on triggers and sensors upon remote arming.

Bypasses faulty system components to maintain protection.

LED on dashboard indicates system status: disarmed, valet, or armed.

System indicates if an intrusion attempt occurred while away.

Meaning of system chirps and parking light flashes for status indication.

Features for silencing or muting arm/disarm chirps.

Information on adding and managing remote controls for the system.

Procedure to erase digital codes of lost or stolen remote controls.

Step-by-step guide to programming system features using the valet switch.

Configure the automatic arming feature of the security system.

Customize the automatic door locking behavior.

Adjust audible confirmation for arming/disarming.

Control door lock behavior based on ignition status.

Set up the warning response for sensor tamper detection.

Procedure to add new remote controls to the system.

Example demonstrating how to change the AutoArming feature setting.

Mount the sensor in the passenger compartment, not the engine compartment.

Connect the ORANGE sensor wire to the ORANGE control unit wire.

Connect the BLACK sensor wire to ground.

Connect the RED sensor wire to +12V.

Locate and connect the ignition switch wire for system operation.

Configure the relay for normally closed or open starter/ignition interrupt.

Mount and connect the siren in the engine compartment.

Connect the hood pin wire for trigger detection.

Configure the lock pulse duration between 1 second and 3 seconds.

Change relay from NORMALLY CLOSED to NORMALLY OPEN or vice-versa.

Change the high/low setting for vehicles with delayed courtesy lights.