AVIX Autonomic Mak II - Spare Parts; Accessories; Troubleshooting

10
• Solar Panel Pole Brackets
• Solar Panel Frame Brackets
• Solar Panel Extension Cable (5m)
Remote access
• AVIX Remote Status & Control Module
• Remote Control (RF) Starter Kit
• Remote Control (RF) Receiver Kit
Extra accessories
• Laser Warning Sign
• Laser Safety Glasses
9. Troubleshooting
If the AVIX Autonomic is not performing as expected, check the bird-
shaped LED indicator on the back of the AVIX Autonomic enclosure to
identify the device status (see status list below). Alternatively, check
the device status in the user interface (see chapter 4; Conguration).
The Autonomic has encountered an error and user action is required.
If the autonomic was bursting it will automatically try to resolve this
error every minute. To check the error type, please connect to the
AVIX Autonomic and check the device status in the user interface (see
chapter 4.2; Connecting to the device).
7. Spare parts
The following AVIX Autonomic spare parts are available:
• AVIX Autonomic Payload (housing including laser and PCB)
• AVIX Autonomic Housing (enclosure only)
• AVIX Autonomic Rear Cap
• AVIX Autonomic Light Module
• AVIX Autonomic Motor Platform
• AVIX Autonomic Power Switch Module
• AVIX Autonomic Mains Power Adapter
8. Accessories
The following AVIX Autonomic accessories are available.
Mounting system
• Vertical Mounting Bracket
• Horizontal Mounting Frame
• Adjustable Frame Extender
• Power Extension Cable (5m)
Solar charging system
• Battery Box Kit (24V)
• Battery
• Solar Panel
LED color LED appearance Status
OFF Static
OFF (no power):
No power to AVIX Autonomic.
Blinking white
OFF (powered):
Press I/O button to switch ON/OFF the Autonomic.
Static purple
Initialization:
AVIX Autonomic is starting up. If this takes more than 20 seconds, disconnect power and try again.
Static yellow
Standby:
The Autonomic is switched on, but either no patterns or timeslots are dened or bursting is disabled.
Static green
Bursting (active):
The Autonomic is running a pattern (caution: laser output).
Static blue
Bursting (pause):
The AVIX Autonomic is waiting to perform its next pattern.
Blinking blue
Bursting (outside timeslot):
The AVIX Autonomic is waiting to return to its predened timeslot(s). No patterns will be played.
Blinking red
Error:
The AVIX Autonomic has encountered an error and user action is required. If the autonomic was
bursting it will automatically try to resolve this error every minute. To check the error type, please
connect to the AVIX Autonomic and check the device status in the user interface (see chapter 3).
Static red
Emergency:
The AVIX Autonomic has stopped working because of the emergency stop on the Power Switch
Module has been pressed. After the emergency stop has been released, the color of the AVIX
Autonomic remains red.