18
Slide the measuring chamber back until it snaps into
position.
See illustration 2-12.
Plug the tubing connector of the reference housing
assembly into the receptacle below the left side of the
measuring chamber.
See illustration 2-13.
Preparing the analyzer for operation
Before the analyzer is powered on, the language
setting must be selected. The factory-set language is
English; to select a different language setting, remove
the paper tray and use a pen to set the switch to the
desired language position as indicated on the label.
Now, locate the power switch on the back of the unit
and make sure that it is in the OFF (O) position.
Next, plug the power cord into the power receptacle
module on the back of the unit, then plug the cord into
a grounded electrical outlet.
See illustration 2-14.
Note: If you decide to change the language after the
unit is powered on, you must cycle the power to
activate the new language.
2-12. Slide chamber backward
2-13. Reference connector
2-14. Power cord installation
To Next Page
Loading...
