6 DSR2035/8035 Switch Installer/User Guide
information on how the DSR switch uses TCP/IP, see the DSView Installer/User Guide or
DSView
3 Software Online Help.
Installing the DSR switch
The general procedure for setting up and installing the DSR2035/8035 switch is as follows:
• Unpack the DSR2035/8035 switch and verify that all components are present and in good
condition. See the
Getting started section in this chapter.
• Make all hardware connections between the power source, DSR2035/8035 switch, target
devices, optional SPC device, the Ethernet and the optional modem connection. See the
Connecting the DSR2035/8035 switch hardware section.
• Turn on the power and verify that all connections are working. See the Verifying the
Connections section.
• If you are configuring the DSR2035/8035 switch using the console menu interface, do that at
this point. See
Chapter 4 for more information.
• Use the DSView Server software to configure the DSR2035/8035 switch. See the DSView
Installer/User Guide for detailed instructions.
• Make the appropriate mouse setting adjustments. See the Adjusting Mouse Settings on Target
Devices section.
Figure 2.1 on page 7 illustrates a basic configuration for the DSR2035/8035 switch, using the
DSR8035 switch as a model for the example.
To Next Page
Loading...
