378 DSView 3 Software Installer/User Guide
Esc [ <sol>; <par>;
Report Terminal Parameters <nbits>; <xspeed>;
<rspeed>; <clkmul>; <flags>x
No/No
Esc [ <sol> x Request Terminal Parameters No/No
Esc 7 Save Cursor No/Yes
Esc [ Pn; Pn r Set Top and Bottom Margins Yes/Yes
Esc # 5 Single Width Line No/No
Esc [ 2; Ps y Invoke Confidence Test No/No
Esc [ Ps n Device Status Report No/Yes
Esc [ Ps J Erase in Display No/Yes
Esc [ Ps K Erase in Line No/Yes
Esc H Horizontal Tabulation Set Yes/Yes
Esc [ Pn; Pn f Horizontal and Vertical Position No/Yes
Esc D Index No/Yes
Esc E Next Line No/Yes
Esc M Reverse Index No/Yes
Esc c Reset to Initial State No/No
Esc [ Ps; Ps;..;Ps 1 Reset Mode No/No
Esc ( A Select Character Set G0 U.K. No/No
Esc ) A Select Character Set G1 U.K No/No
Esc ( B Select Character Set G0 ASCII Yes/Yes
Esc ) B Select Character Set G1 ASCII Yes/Yes (limited support)
Esc ( 0 Select Character Set G0 Spec. Graphics Yes/Yes (limited support)
Esc ) 0 Select Character Set G1 Spec. Graphics Yes/Yes (limited support)
Esc ( 1
Select Character Set G0 Alt. Character ROM
Standard Character Set
No/No
Esc ) 1
Select Character Set G1 Alt. Character
ROM Standard Character Set
No/No
Esc ( 2
Select Character Set G0 Alt. Character ROM Special
Graphics
No/No
Table D.7: VT100 ANSI Mode Control Sequences (Continued)
Control Sequence Definition Encode/Decode
To Next Page
Loading...