AVPro Edge AC-EX40-444-KIT User Manual (English)

To Next Page

40M, 70M & 100M 18Gb ps 4k60 (4:4:4) HDBaseT Extenders with ICT

444 Extenders

quick start guide

AVPro Edge presents our 18Gbps over copper HDMI extender. Using ICT (Invisible

Compression Technology) we can deliver a virtually lossless high bandwidth 4K HDR

signal with support for all signals up to 18Gbps. Deep Color and HDR Metadata remain

intact making the transmission free of artifacts like banding.

There are 3 different models in the 444 Extender series. Each step up in the series

not only supports longer distances, but also upgraded features. Each extender kit

consists of two main pieces, a transmitter (Tx) and a receiver (Rx). The majority

of this Quick Start Guide refers to the AC-EX40-444-KIT. You will nd specic

information pertaining to the AC-EX70-444-KIT and the AC-EX100-444-KIT towards

the end of the guide. This guide will walk you through the following topics:

• Installation

• EDID Management

• Scaling

• Test Pattern Generator

• IR Control Signals

Installation of the Extender:

1. Install a CAT5e (or better) cable between the

display and the source (be sure to follow local

low voltage code. This varies state to state).

2. The Tx has an HDMI input. Connect this to the

output of the source with an 18Gbps HDMI cable.

3. The Rx has an HDMI output. Connect this to the

input of the display with an 18Gbps HDMI cable.

4. Both the Tx and Rx have an RJ45 HDBT

connector. Connect each end of the installed

Category cable to these ports.

5. Both the Tx and Rx have an orange 2 pin power connector. You only need to power the Rx or the Tx, not both.

You will notice that the Rx has a switch labeled “POE”. This indicates where power originates from. If you power

the Tx, be sure this switch is in the “Tx” position, and if you power the Rx be sure that the switch is in the “Rx”

position.

*NOTE - Only use the included power supply.

• RS232 Control Signals

• Audio Extraction

• Ethernet (AC-EX70-444-KIT & AC-EX100-444-KIT only)

• USB Extension (AC-EX100-444-KIT only)

• Troubleshooting

AC-EX40-444-KIT

AC-EX70-444-KIT

AC-EX100-444-KIT

AVPro Edge AC-EX40-444-KIT Quick Start Guide