Need help?Do you have a question about the AVS Electronics TS85 V LED Plus and is the answer not in the manual?
General| Brand | AVS Electronics |
|---|---|
| Model | TS85 V LED Plus |
| Category | Security System |
| Language | English |
Covers siren behavior, timers, sound, alarm counts, flash modes, and control inputs (STC, LED, Block).
Details failure signaling (microprocessor, battery, flash, LED, cone) and tamper detection (removal, vibration, heat, foam).
Includes battery polarity protection, current limiting, and installation level indicator.
Describes periodic checks for LED, Cone management, Cone, and battery performance.
Details power, voltage, consumption, sound pressure, frequency, battery, protection, operating temperature, and dimensions.
Explains the function of each terminal for wiring and setup.
Instructions on how to remove the external and internal covers of the siren.
Steps for preparing wall mounting holes, fixing the siren, and installing anti-removal devices.
Guidance on connecting to the control unit, initial setup, and closing the siren cover.
Illustrates default and balanced input connections for control units.
Explains how the siren operates during alarm, encoding, and standby modes.
Details how to access, perform, and exit the programming sequence.
Describes SA unbalancing, STC/LED unbalancing, alarm encoding, sound tones, and tamper settings.
Details flash modes, STC input behavior, and LED input configurations.
Explains how faults (battery, foam, thermal, power, cone, flash) and tampers are signaled.
Configures sound level and maximum alarm duration for main and alternative sounds.
Sets LED behavior (fixed, flashing, quick flash) for input status changes.
Details viewing and deleting fault/tamper event memories.
To Next Page
