AVT AVC 776 - Page 18

18
3.5.12.1 Press ” Up ” or “ Down ” to choose CLEAR HDD setup.
3.5.12.2 Press ”
ENTER ” to confirm CLEAR HDD setup.
3.5.12.3 Press ”
Up ” or “ Down ” to choose CLEAR HDD setup YES or NO.
YES: Confirm to clear HDD, and screen will show followings.
ALL DATA IN HDD
WILL BE CLEARED
ARE YOU SURE?
(◄ : NO ► : YES )
Press“ ►” to clear HDD
NO: Confirm not to clear HDD.
3.5.12.4 Press ”
MENU ” to exit and confirm current operation.
3.5.12.5 Press ”
MENU ” again to exit and close SYSTEM setup mode.
3.5.13 SYSTEM RESET setup
This device allows user to reset the system.
3.5.13.1 Press ”
Up ” or “ Down ” to choose SYSTEM RESET setup.
3.5.13.2 Press ”
ENTER ” to confirm SYSTEM RESET setup.
3.5.13.3 Press ” ”
Up ” or “ Down ” to choose SYSTEM RESET Yes or No
YES: To confirm System Reset (load default system reset)
NO: Confirm not to System Reset
3.5.13.4 Press ”
MENU ” to exit and confirm current operation.
3.5.13.5 Press ”
MENU ” again to exit and close SYSTEM setup mode.
3.5.14 REMOTE MODE setup
This device allows user to set the remote mode.
3.5.14.1 Press ”
Up ” or “ Down ” to choose REMOTE MODE setup
3.5.14.2 Press ”
ENTER ” to confirm REMOTE MODE setup
3.5.14.3 Press ”
Up ” or “ Down ” to choose Interface for REMOTE MODE setup
RS-232: Use RS-232 interface
RS-485: Use RS-485 interface
3.5.14.4 Press ”
MENU ” to exit and confirm current operation.
3.5.14.5 Press ”
MENU ” again to exit and close SYSTEM setup mode.
3.5.15 Remote protocol Transmitting Baud Rate setup
This device allows user to set the remote protocol transmitting baud rate.
3.5.15.1 Press ”
Up ” or “ Down ” to choose Baud Rate setup.
3.5.15.2 Press ” ENTER ” to confirm