m542_543_quick_V1.5
PREVIEW WITH CCTV TESTER MONITOR CABLE OVERVIEW DEFAULT VALUES
FOR SELECTED MODELS ONLY
This camera support composite output for you to preview the viewing angle if it’s correct or not while
installing camera. Find the receptacle housing of a RCY connector in the camera, and get a suitable plug
to connect to a CCTV tester monitor.
Please follow the specifications as below to purchase the suitable plug.
Specification of contact Specification of housing
0.64
15.8
1.7 2
1.7
1.7
11
1.8
2
1.1
9.5
2.5
2.9
6.7
2.5
3.2
5.3
6.3
13
4.3
19
Receptacle housing (for pin contact) Plug (for socket contact)
Overview of optional plug cable
Connect to a RCA cable
DDD
Cable Description
Power cable DC12V power supply.
RJ45 network cable* Connect it to a RJ45 cable.
GND Ground wire
Alarm-in**
Reserved for external alarm
device connection
Alarm-out**
Reserved for external alarm
device connection
RESET
Remove the insulating coating o
wire, and twist it with a ground
wire together to reset default
camera
Line-in**
Colored as blue, used to
connect to a microphone for
audio input.
Line-out**
Colored as green, used to
connect to a speaker for audio
output.
* For PoE (IEEE802.3af) installation, make sure your network
cable has the maximum cable resistance of 20Ω, such as
CAT.5e or CAT.6 cables, to conform to the standard of
IEEE802.3af.
** For selected models only
IP address 192.168.1.10
Port number 88
User name admin
Password admin
It's strongly recommended to change the default
user name and password before using the
camera to keep your account safe.
To change the default account, log into the
camera, and go to Config. General
Account. Create a new account, and remove
the default one.
SYSTEM CONNECTION
1. Connect IP cameras and a monitor to the NVR, and power on the NVR, as illustrated below.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
2. Wait till each camera is configured automatically and you will see camera images on the monitor
soon.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
Type1 Type2
To Next Page
Loading...
