AWS PK-110 - Operation; Hold Settings

PK-110 Manual
Low batteries can cause inaccuracy in digital scales. If
youareexperiencingissueswithyourscale,rsttrynew
batteries. Most times, this will solve the problem.
1. Beforeusingthescaleforthersttime,check
the battery compartment and remove any plastic
insulation strips or packaging that may be in place to
prevent battery drainage during shipping/storage.
2. If you are replacing the batteries, make sure the
positive and negative contacts are properly aligned.
IV. Operation
1. Press the ON/OFF ( ) key to turn the scale on.
2. Once the start-up process completes and the scale
goes to zero you are ready to weigh.
3. Place the quantity to be weighed onto the weighing
hook.
4. Wait a couple seconds for the display to stabilize
before taking a weight reading.
5. To turn the scale OFF, press the ON/OFF key again.
V. Hold Settings
This scale has three different hold settings. Follow these
instructions to change the hold setting:
1. With the scale OFF, press and hold the Z/T key, then
tap the ON/OFF ( ) key. Release both keys when
you see “------” on the display.
2. Tapping the Unit key will cycle through the three
hold settings: