OPEN YOUR SAFE FOR THE FIRST TIME
INSERTING THE BATTERIES
OPEN THE SAFE / OPEN THE DOOR
CLOSING THE DOOR
When commissioning please use the emergency key. Remove the protective
cover (5) and insert the emergency key. Rotate the key clockwise. After
commissioning, keep safe the emergency key on a safe place. In no case
should you Keep the emergency key in the safe.
Open the safe door and place 4x AA batteries into the battery compartment (3).
If the GREEN LED (6) and the RED LED (7) are lit at the same time, the voltage
is too low. In this case, you have to replace the batteries with new ones. Please
ALWAYS replace ALL 4 BATTERIES! Take care when you insert the batteries for
correct placement and polarity (+ and -). If the safe is left without power for
more than 30 minutes, the PIN becomes automatically reset to factory settings.
Enter your PIN-NUMBER (3 to 8-digit). By pressing the buttons an acoustic
tone sounds a the YELLOW LED (8) lights up. After entering the PIN NUMBER
press the confirm button "#" (9) to confirm the PIN entry. The GREEN LED (6)
confirms the correct one Input. Turn the door opener (4) clockwise to open
the door.
Turn the knob (4) counter to the clockwise to the left to close the door.
To Next Page
Loading...