Axis 200+ - Using RARP in UNIX

Section 3: Assigning an IP Address AXIS 200+ Users Manual
28
Using RARP in UNIX
Follow these steps to use the RARP method in UNIX:
1. Append the following line to your Ethernet address table. This is
typically performed using the command
/etc/ethers
:
Example:
2. If necessary, update your host table and alias name databases as
described required by your system.
3. If it is not already running, start the RARP daemon. This is typically
performed using the command
rarpd -a .
4. Restart the AXIS 200+ to download the IP address.
<Ethernet address> <host name>
00:40:8c:10:00:86 cameraname