Axis 200+ - Using BOOTP in UNIX

AXIS 200+ Users Manual Section 3: Assigning an IP Address
29
Using BOOTP
in UNIX
Follow these steps to use the BOOTP method:
1. Append the following entry to your boot table. This is typically
performed using the command
/etc/bootptab:
where:
Example:
2. If necessary, update your host table and alias name databases as
described required by your system.
3. If it is not already running, start the BOOTP daemon. This is
typically performed using the command
bootpd .
4. Restart the AXIS 200+ to download the IP address, default router
address, and subnet mask.
<host name>:ht=<hardware type>:vm=<vendor magic>:\
:ha=<hardware address>:ip=<IP address>:\
:sm=<subnet mask>:gw=<gateway field>
ht
= ether
vm
= rfc1048
ha
= The Ethernet address of the AXIS 200+
ip
= The IP address of the AXIS 200+
sm
= The subnet mask
gw
= The default router address
cameraname:ht=ether:vm=rfc1048:\
:ha=00408c100086:ip=
172.16.253.80
:\
:sm=255.255.255.0:gw=172.16.1.1