AXIS 200+ Users Manual Appendix B: The Parameter List
73
Factory Default Settings
If you should need to reset the AXIS 200+ to its factory default
settings, you can use the Control button. Follow these steps:
1. Switch off the AXIS 200+ by unplugging the power cord.
2. Press and hold the Control button while you switch on the AXIS
200+. Keep the Control button pressed until the Snapshot
indicator flashes at regular two second intervals.
3. Release the Control button and wait at least two seconds (one
flash of the Snapshot indicator).
4. Press and hold the Control button for at least five seconds until
the Snapshot indicator remains constantly lit.
5. If you need to restore the default Internet address, press and hold
the Control button once again until the Snapshot indicator starts
flashing. Otherwise, the Internet address setting remains
unchanged.
6. The AXIS 200+ is now reset to factory default settings. Restart the
AXIS 200+ by switching it off and on.
Note:
❏ The node address (NODE_ADDR parameter) remains
unchanged, but all other parameters are reset.
TIME. =
The current time.
DATE_SERVER. = 0.0.0.0
Internet address of the server that provides the actual time and
date.
DATESYNC_PERIOD. = 0
The date and time will be automatically updated according to the
specified intervals.
DATESYNC_PROTOCOL. = TIME
The synchronization protocol used. Time (serial port 37), Day-
time (serial port 13) or NTP (UDP port 123).
DATESYNC_TIME_ZONE. = 0
The time zone adjustment as number of hours +/- UTC.
TIMEADJ_WEEK. = 0
The time adjustment per week.Valid range is 0 to (-)32000 sec-
onds.
WATCHDOGTIME. = 12000
Do not change.
INDEX_FILE. = INDEX
Parameter name Value Description
To Next Page
Loading...
