Need help?Do you have a question about the Axis P5534 Outdoor T95A00 Kit and is the answer not in the manual?
General| Tilt Range | 180° |
|---|---|
| Outdoor Ready | Yes |
| Environment | Outdoor |
| PTZ | Yes |
| Pan Range | 360° |
| Power over Ethernet | Yes |
| Camera Type | PTZ |
| Protocols | HTTP, HTTPS, RTSP, RTP, TCP, UDP, IGMP, RTCP, ICMP, DHCP, ARP, DNS, NTP, UPnP, Bonjour, SNMP, SMTP, IPv4, IPv6 |
| Video Compression | H.264 |
| Frame Rate | 30 fps |
| Audio Compression | AAC, G.711, G.726 |
| Local Storage | SD card slot |
| Power | PoE (IEEE 802.3af) |
| Sensor | 1/2.8" CMOS |
| Lens | Varifocal |
| Weather Protection | IP66 |
| Storage | SD card slot |
| Audio | Yes (built-in microphone) |
Provides warnings for high voltage and cautions for product handling.
Outlines the main steps: check contents, install hardware, set IP, set password.
Steps for mounting the bracket to a wall using appropriate screws.
Aligning the housing with the bracket and tightening screws.
Verify cable connections, replace cover, and connect power.
Assign IP address and set password for network setup.
Introduces DHCP, static IP, AXIS IP Utility, and Camera Management.
Details using AXIS IP Utility for single camera setup.
Details using AXIS Camera Management for multiple cameras.
Steps for automatic discovery of cameras using AXIS IP Utility.
Automatic discovery of Axis devices using Camera Management.
Process for assigning IP addresses to multiple devices in a range.
Steps to set the root password using HTTP or HTTPS.
Guide for creating an HTTPS certificate for secure password setup.
Step-by-step guide to reset the camera to factory default settings.
To Next Page
