SOP for CCTVs in SunGuide
After reassembling the camera, use a laptop to configure the camera.
Connect an Ethernet cable from the laptop Ethernet port to the DATA IN port on the
midspan (PoE injector/ power supply) provided.
Connect the special shielded Ethernet cable from the midspan (PoE injector/ power
supply) DATA & Power OUT port to the camera.
Connect the AC power cord to the midspan.
Apply on Power to the camera.
Once the camera is powered and the camera is in factory default state. The default IP address
for the camera is 192.168.0.90.
Log into the camera, using Internet Explorer or Chrome to access the camera’s user interface.
Type in the default IP address.
To Next Page
Loading...
