Need help?Do you have a question about the Axis Q6045-E Mk II and is the answer not in the manual?
General| Type | IP security camera |
|---|---|
| PTZ control | Yes |
| Certification | NEMA 4X\\r IK10 |
| Placement supported | Outdoor |
| Connectivity technology | Wired |
| Form factor | Dome |
| Mounting type | Ceiling/wall |
| Product color | White |
| Housing material | Aluminum |
| International Protection (IP) code | IP66 |
| Maximum resolution | 1920 x 1080 pixels |
| Supported video modes | 1080p |
| Video formats supported | H.264, M-JPEG |
| Supported graphics resolutions | 320 x 180, 1920 x 1080 (HD 1080) |
| Pan range | 0 - 360 ° |
| White balance | Auto |
| Tilt angle range | 0 - 220 ° |
| Camera shutter speed | 0.000030303 - 0.33 s |
| Minimum illumination | 0.03 lx |
| Sensor type | CMOS |
| Optical sensor size | 1/2.8 \ |
| Digital zoom | 12 x |
| Optical zoom | 32 x |
| Focus adjustment | 1.6 - 4.41 |
| Focal length range | 4.44 - 142.6 mm |
| Security algorithms | HTTPS, SSH, SSL/TLS |
| Password protection type | User |
| Built-in HDD | No |
| Flash memory | 128 MB |
| Internal memory | 512 MB |
| Compatible memory cards | SD, SDHC, SDXC |
| Cabling technology | 10/100Base-T(X) |
| Supported network protocols | IPv4/v6, HTTP, HTTPS, SSL/TLS, QoS Layer 3 DiffServ, FTP, CIFS/SMB, SMTP, Bonjour, UPnP, SNMP v1/v2c/v3 (MIB-II), DNS, DynDNS, NTP, RTSP, RTP, SFTP, TCP, UDP, IGMP, RTCP, ICMP, DHCP, ARP, SOCKS, SSH, NTCIP |
| Compliance industry standards | PoE IEEE 802.3at |
| Interface | RJ-45 |
| Ethernet LAN (RJ-45) ports | 1 |
| AC input voltage | 100-240 V |
| Power source type | PoE |
| Storage temperature (T-T) | -50 - 60 °C |
| Operating relative humidity (H-H) | 10 - 100 % |
| Bundled software | AXIS Camera Companion, \\r AXIS Camera Station, \\r Video management |
Weight and Dimensions| Height | 280 mm |
|---|---|
| Weight | 3700 g |
| Diameter | 232 mm |
Details the physical ports, buttons, and connectors on the camera unit.
Instructions for accessing the product's interface via a web browser.
Procedure for setting the initial administrator password for secure access.
Provides initial configuration steps for using the product.
Configuration options for defining video stream properties like resolution and compression.
Configuration of shock detection and basic motion detection parameters.
Defines conditions to trigger actions like recording or notifications.
Configures user access, security settings, and network protocols like HTTPS.
Settings for TCP/IP, DNS, NTP, DHCP, and NAT traversal.
Manages SD cards, network shares, and recording storage settings.
Checking firmware version, upgrading, and emergency recovery procedures.
Resolving issues related to setting or accessing the product via IP address.
Troubleshooting problems with browser access, logins, and external connectivity.
Detailed technical specifications for the camera hardware and lens.
Technical details regarding video compression, resolutions, and streaming capabilities.
To Next Page
