AXITEC AC Series - Introduction; Codes and Regulations

Installation and Operating Guide
AUS240729 3
1 INTRODUCTION
Thank you for choosing AXITEC ENERGY GMBH & CO. KG solar modules. With proper operation
and maintenance, AXITEC ENERGY GMBH & CO. KG modules will provide you with clean and
renewable solar electricity for years to come. This manual contains necessary installation,
maintenance, and safety information. Keep this guide in a safe place for future reference.
Non-compliance with this installation instruction may result in property damage and/or physical
injury. AXITEC ENERGY GMBH & CO. KG will not be liable for compensation of any loss or injury
caused by this type of non-compliance.
AXITEC ENERGY GMBH & CO. KG reserves the right to make unannounced alterations to the
design and/or technical specifications of its solar modules at any time. Therefore, only the datasheet
current at the time of manufacture is definitive. It is therefore expressly recommended to ensure that
the datasheets on hand represent the current status before placing an order. When performing
assembly or other work on the solar modules, the datasheets and user information current at the
time of manufacture of the relevant module are to be used for reference. The contents of older or
newer documents may be incorrect due to interim product changes.
This version of “Installation & Operating Instructions” replaced all other before.
1.1 Module type
This manual is valid for following module types:
AC-xxxM/60S: xxx = 310 – 325; AC-xxxMH/120S: xxx = 310 – 335
AC-xxxM/72S: xxx = 370 – 390; AC-xxxMH/144S: xxx = 370 – 405
AC-xxxMH/120VAU: xxx = 360 – 385; AC-xxxMH/144VAU: xxx = 440 – 465
AC-xxxMH/108VAU: xxx = 400 – 415; AC-xxxMH/144VAU: xxx = 530 – 555
AC-xxxMH/108KAU: xxx = 400 – 415; AC-xxxTGB/108BBA: xxx = 430; 440
AC-xxxTGB/108WBA: xxx = 430 – 440; AC-xxxTGB/120BBA: xxx = 470
AC-xxxTGB/120WBA: xxx = 470; AC-xxxTGB/144TSA: xxx = 565 – 580
AC-xxxTGBL/108WBA: xxx = 440-450; AC-xxxTGBL/108BBA: xxx = 440-450
AC-550TGB/120TSA: xxx = 550
2 Codes and regulations
The mechanical and electrical installation of PV systems should be performed in accordance with all
applicable codes, including electrical codes, building codes and electric utility interconnection
requirements. Such requirement may vary for mounting location. Requirements may also vary with
system voltage, and for DC or AC application. Contact local authorities for governing regulations.