Before using your Duox child restraint ensure all
steps in this instruction manual have been
followed and that the restraint has been correctly
installed.
Ensure the child restraint is in its most
upright position. If adjustment is need-
ed, press the Recline adjustment lever (4)
and push on restraint until completely
upright. Now your Duox is ready to be
used as a booster seat.
Installation in vehicle
Place the Duox child restraint onto
the vehicle seat, then place your child
into the restraint. Guide the diagonal
part of the seat belt through the red seat
belt guide located in the headrest(6) just
above your child’s shoulders. Proceed to
guide the seat belt over the lower seat belt
guides marked in red (6) just above the
seat’s armrests. You may need to move
the restraint slightly sideways to allow
the seat belt to comfortably t in the seat
belt guides. Feed the lap section of the
seat belt through the lower belt guides
marked in red underneath the armrests
(7) and engage into the vehicle’s seat belt
buckle. e seat belt must not be twist-
ed or tangled in any way, and must be
tensioned rmly. Picture B describes the
routing of the seat belt.
19
7
6
Picture B
Step 0
Step 1
Step 2
To Next Page
Loading...
