Once there is an audible click and both
indicators (4) are green they are properly
secured. To remove the Duox child re-
straint, hold both of the release buttons
(5).
To adjust the angle of the child restraint,
press the Recline Adjustment Lever (6) to
select one of the three reclining positions.
Always choose the most upright position
as possible, however your child must be
able to hold their head up on its own, and
there should be enough recline to ensure
your child’s head does not fall forward
when sleeping. e rule of thumb is that
the older the child grows, the more upright
the seat can be installed. Please note that
once the installation of the Duox is com-
plete, it will be somewhat more reclined as
it sinks into the vehicle’s seat when tight-
ening seat belts and tether straps.
Attaching the lower tether straps
Some vehicles may already be tted with
anchorage points at the base of the front
seat rails.
If your vehicle does not have these anchor
points, the supplied lower tether straps
must be used to create anchor points. For
tips on how to install these tether straps
please see the example on the next page.
e anchoring point needs to be as close
to the oor as possible. In doing so you
should always insert the buckle through
the closest appropriate slot in the strap
to create a slip knot and pull tight. is
needs to be repeated on both sides to cre-
6
Continued on next page
5
4
6
Lower tether straps
To Next Page
Loading...
