Axkid Duofix - Page 9

9
ate two anchor points. When installing
Duox in the front passenger seat the
tether straps must be attached to the front
gliding tracks so the tether points will be
located along the front edge of the passen-
ger seat.
Pull out the upper anchorage strap from
the belt housing (7) to an appropriate
length. Check that the white marking on
the strap (8) is visible. If not, you can try
crossing the straps over to give them some
extra length to enable the white marking
to be visible. Clip the anchor attachment
directly onto the anchorage point. Repeat
on the other side. Press down hard on the
on the red mark(9) on the top right side of
the child restraint then repeat for the left
side(9). When you do this its important
that you really use your full body weight
to press down and get the tether straps to
really tighten hard. is will give the an-
chorage straps their rst tightening.
Unfold the support leg (10) out to its
maximum angle. Pull out the top latch
to release the upper part of the support leg
(11) until it reaches the oor. If the sup-
port leg does not reach the oor, repeat
with the lower latch (11). Its important
that you check that the support leg is an
angle over 80 degrees from the back of the
seat. You could check this by ensuring that
the support leg is further away from the
seat then the vertical line(12). Press down
on the child restraint from side to side
again, the anchorage straps will be then be
automatically tightened.
7
10
11
8
Continued on next page
11
12
9