EasyManua.ls Logo

Axkid Move - Child Seat Parts; Allowed and Disallowed Positioning; Rear-facing Installation Requirements

Axkid Move
86 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
The child restraint can be used on any forward facing passenger seat which has a 3-point seat belt (i),
so long as there is no active airbag in place. The child restraint cannot be used with a 2-point lap belt (ii).
IMPORTANT: If you wish to install your Move in a location where an airbag is fitted, then the airbag
must be disconnected at an authorized service centre. Some vehicles may be equipped with a switch
which allows you to manually switch the airbag o. It is important to always check if the vehicles
indicator light shows that the airbag is turned o.
WARNING: Never use on a seat with an active airbag
WARNING: Never use on rearward or side facing vehicle seats
WARNING: Air bags are designed for adults and can seriously harm your child in a crash
Parts
1
A Headrest K Side impact pad connector
B Integral harness L Tether straps
C Harness buckle M Belt lock-o
D Seat belt slot N Grey button
E Harness adjuster button O Pocket for storage of instruction manual
F Harness adjustment strap P Zip
G Recline block Q Support leg
H Side impact pad R Leg extension button
I Heels S Yoke
J Indented vertical line
Allowed and disallowed positioning of the child
car seat
Contents
Parts 4
Allowed and disallowed positioning of the child car seat 4-5
Rear-facing 9-25kg with vehicle seat belt and tethers
This assembly can be used for children weighing between 9-25 kg (20-55 lb).
5-9
Removing and fitting the covers 9
Care and maintenance 10
Warranty 10
The Move child restraint is suitable for use from approximately six months of age, or from when your
child can sit up unsupported, up until the age of six. This child restraint can ONLY be installed rear-
facing.

Related product manuals