5
Allowed and disallowed positioning of the child car seat.
Front passenger seat (no active airbag) Yes
Front passenger seat (active airbag) NO
Forward facing seat with 3-point seat belt Yes
Seat with 2-point seat belt NO
Side facing seats NO
Rear facing seats NO
Never use this child seat in a car that is not equipped with an
ECE Reg 16 approved three-point belt.
Before you install the child restraint make sure that the headrest is at the correct height for your
child. The harness, when correctly installed, should be routed from the back of the seat to the
front and pass just above your child’s shoulders.
In order to adjust the height of the headrest and harness you will first need to detach the
harness. Press the harness adjuster button (E) and pull forward on the shoulder straps (not the
shoulder pads) to completely loosen the harness.
Open the zipper (P) on the back of the seat cover.
Unhook the shoulder straps from the yoke (S) at the back of the child restraint.
Unfasten the Velcro® and detach the shoulder pads (B) on the back of the seat.
Pull the shoulder pad straps and shoulder straps out from the seat.
Squeeze the plastic clip and gently pull the headrest free from the seat.
Reposition the headrest at one of the three heights that best suits your child. Push the bottom
of the headrest until the plastic clip locks in place.
2
3
4
5
6
7
8
9
Adjusting the headrest and harness height
Rear-facing 9-25 kg with seat belt & tethers
To Next Page
Loading...
