EN
29
8. Place the bag on its back on the oor. Position the two support rods in the lower and upper tubes (g. 16). Do not bend the rods too
much, as this may cause them to loose supporting tension.
9. Feel along the upper side tube to locate the lower hole. Make a hole in the bag in line with the lower hole (g. 17). Insert a lock pin
through the hole and attach the bag holder on this (g. 18). Now place a plastic cap on the end of the bag holder. Repeat on the other
side.
13 14 15
Ø2 sprint
Upper hopper
side tube
Flap
Snap
Lower hopper
side tube
Ø3 hair
cotter pin
Hopper bag
bottom
Ø9,5x25
clevis pin
Ø6x37
clevis pin
Bag frame
strap
16 17 18
Support rod
Upper hole
Lower hole
Upper hopper side tube
Ø3 hair cotter pin
Lower
hole
Bag arm
tube
Ø8x59,6
clevis pin
Vinyl cap
Bag arm
tube
10. Secure the rope to the middle of the upper rear tube (g. 19).
11. Fit the hopper bag on the chassis (g. 20).
19 20
Ø6x37
clevis pin
Ø2 hair
cutter pin
Bag arm
tube
To Next Page
Loading...