Continues Over....
Scoring Blade
1. Remove the side panel (9), see fig 140.
2. Release the tension from the drive pulley by lifting
up the tension pulley (b) which in turn allows the belt
to be removed, see fig 145-146.
3. Check the condition of the belt. If you find there
is fraying or stretchinge replace the belt.
4. Place the new belt over the pulley as shown in fig 145
and re-tension with the tension pulley. Turn the belt by
hand to make sure the belt has seated down properly.
Fig 145-146
Drive belt
Belt tension pulley
5. Replace the side panel (9), reconnect the machine to
the mains give the machine a test run ( i.e. quick ON-OFF)
to ensure everythinge is O.K. If everythinge is satisfactory,
continue to use the panel saw.
b
Lubrication
After every three or four months we recommend you
lubricate the blades and the tilt, rise and fall screw
threads using ‘Ambersil Dry PTFE Film Antistick’ spray,
see fig 147-148.
Fig 147
Ambersil Dry PTFE Film Antistick spray
Fig 148
Rise & fall thread
Tilt thread
Main blade
Scoring blade
To Next Page
Loading...
