nergen PRO
28
5. OPERATION
IMPORTANT: 3.000 r.p.m. Generating Sets mustn´t be operating over 4 hours continuously.
STARTING GASOLINE ENGINE
Before starting the generator, make sure that it is not connected to any electric machine.
Follow the steps below in order to start the generator:
MANUAL STARTER:
- Turn the fuel valve to the ON position.
- To start the motor when it is cold, turn the choke to the CLOSED position.
- To start the motor when it is hot, turn the choke to the OPEN position.
- Then turn the engine switch to the ON position.
- Pull the starter handle lightly until you feel resistance. Then pull hard. Slowly release the
starter handle.
ELECTRIC STARTER:
To start an electric start generator, turn the key to the Start position and hold it until the motor starts.
If it doesn’t start after 5 seconds, let off the key and wait at least 10 seconds before trying to start it
again.
Important: If you use the electric starter for more than 5 seconds at a time, the starter will overheat
and can break.
When the motor starts, release the key, allowing it to return to the ON position.
If you moved the choke to the CLOSED position in order to start the motor, gradually move it to the
OPEN position as the motor warms up.
DO NEVER TOUCH THE ACCELERATION LEVER.
THE ENGINE OF THIS GENERATOR HAS BEEN REGULATED TO
THE APPROPIATE REVOLUTIONS IN ORDER TO HAVE A PERFECT OPERATION.
OPEN
CLOSED
CHOKE SWITCH
To Next Page
Loading...