nergen PRO
TURNING THE GASOLINE ENGINE OFF
If you need to turn the motor off in the event of an emergency, just turn the engine switch to the OFF
position. In normal situations, use the following procedure:
- Disconnect all of the devices connected to the outputs of the generator.
- Turn the switch to the OFF position.
- Turn the fuel valve to the OFF position.
If it is an electric start motor, turn the starter to the OFF position.
6. MAINTENANCE
Maintenance is essential in order to keep the generator in good working condition. Improper
maintenance or not repairing a problem could be the cause of improper functioning and could run
the risk of causing serious injury or even death.
That is why we recommend the following:
- Before performing any type of maintenance, let the generator cool down for at least fifteen
minutes if it was running.
- We suggest the following maintenance program:
29
FIRST
MONTH OR
20 HRS
EVERY
THREE
MONTHS
OR 50
HRS
ACTION
MAINTENANCE
ITEMS
EVERY
SIX
MONTHS
OR 100
HRS
EVERY
YEAR OR
200 HRS
Every 500
hrs *
Motor Oil
Air filter
Sedimentation cup
Spark plug
Combustion chamber
Valve clearance
Valves
Fuel tank / filter
Check the oil
Change
Check
Clean
Clean
Check-Adjust
Change
Clean
Check-Adjust
Clean
Clean
*
*
*
EACH USE
Change
* Servicing for these parts should be done by a specialist, unless you have the proper tools
and mechanical knowledge needed.
AIR FILTER
A dirty filter restricts the flow of air to the carburetor, reducing the motor’s performance. If you use
the motor in dusty places, clean the air filter more often than what is specified in the maintenance
program. It should be mentioned that if you turn the motor on without the air filter in place or with a
damaged filter, dirt will get inside the motor and will make it wear out quickly. This type of damage
is not under warranty. To check and clean it, please see the manufacturer’s motor manual.
To Next Page
Loading...